View Single Post
  #5  
Old 05-21-2014, 06:09 AM
trentesept trentesept is offline
MetalShaper of the Month Dec '14
 
Join Date: Jan 2014
Location: Melbourne, Australia
Posts: 58
Default

Next was refining the flange to angle back at the 20 degrees to suit the driving position in the car and to try and make the whole thing a bit neater.
(the standards are sure high on here!!)
Then mark out the back and put it through the slip rollersIMG_0658.jpg

IMG_0659.jpg

IMG_0661.jpg

IMG_0662.jpg
__________________
Greg Smith
Reply With Quote