[Jack 1957]

OK, it's time to let this gigantic hood down. The tape lines are 2" wide for the drop. I will also be cutting the depression running down the center of the hood where the chrome strip and hood ornament were. First thing to do is align the fenders as near perfect as possible. Then align the hood to the fenders. Once that is done, tack the hood to the fenders and cut. The area being removed was carefully located to stay out of any radiused areas. You can avoid a lot of extra work if you do this. I have a little over 2" between the two curves on the hood so I placed the cut there.





Before going any further mark some reference lines equal distance from the center. One on each side. Make sure they are beyond where you will be cutting. Once the center strip is cut out, you can use these lines to find the center again. I'll be cutting a 1" strip out of the center because of the trim depression.