Quote:
Originally Posted by Scott Hightower
When it comes time to join thin sheet metal you will likely want a small mig welder. For your work you can get away with a 110volt machine running .023 wire. If it is in the budget you can upgrade to a 220 volt welder and gang install a double 110 breaker to get the power you need.
Scott
welders360.com
|
If you are intending to make panels I would consider a little tig welder over a mig. I prefer to use gas welding for most of the welds I do. Mig welds are hard and very difficult to dress out.
Look into the various welding methods and consider very carefully before deciding, A lot depends on what use you are likely to put it to. There are several threads on here about this subject.
David