Thread: How to do it ?
View Single Post
  #2  
Old 03-15-2018, 06:05 AM
Peter Tommasini Peter Tommasini is offline
MetalShaper of the Month May 2013, Dec 2013
 
Join Date: Apr 2011
Location: Melbourne,Victoria, Australia
Posts: 7,750
Default

One way can be...
2/3 mm laser cut steel to shapes, bend them round to suit shape use male and female clamp them together and press them in over something round, drill a few holes to keep them in place then weld holes up.

Another way...
Would be to block with small blocking hammer the tops lines then with a hammer and dolly square top lines, use a small dolly on the bottom of the top line and with chasers and a proper dolly drop the lower line down
I used the same method to make all the lines on the Monaro quarter
Peter
__________________
P.Tommasini

Metalshaping tools and dvds
www.handbuilt.net.au

Metalshaping clip on youtube
http://www.youtube.com/watch?v=WEAh91hodPg

Making Monaro Quarter panel:
http://www.youtube.com/watch?v=KIpOhz0uGRM
Reply With Quote