View Single Post
  #27  
Old 03-20-2016, 08:01 PM
RockHillWill RockHillWill is offline
MetalShaper of the Month Jan 2019
 
Join Date: Oct 2009
Posts: 3,089
Default

The top wheel by Joe Andrews looks Very nice and fits very well also. The hammer in the photo was not required to get the wheel in place, I just had it started at a little bit of an angle. I forgot to insert the sleeve between the bearings and was puzzled at first that the wheel seemed a little 'tight'. Every thing match fit very well. I will call Joe in the morning and thank him for his nice work! That piece that Jimmy and I are working on was intended to be similar to the door panel You and I worked on at Oblong, and it worked out quite well the first time we tried it. One area was just a 'tad' lower than it should have been and we re-inserted it and rolled gently in that area and it brought it up to match the rest of the panel with no marks. Jimmy still has a smile on his face.
__________________
Will
Reply With Quote