View Single Post
  #20  
Old 07-10-2018, 01:25 PM
ScooterCO ScooterCO is offline
Member
 
Join Date: Mar 2013
Location: Parker, CO
Posts: 41
Default

We might as well finish this post. Sorry for the delay but I became a new grandfather since my last post.
I need to mention that the Aluminum that was purchased was 5052 in 080. Plenty stiff for this project so no beads or flairs were needed..
After all of the pieces were fabricated it was then check for lay out. Cutouts for fan locations and clearance.
Then installed Nutserts and welded the project to life!
Then added a makers mark.

All went as planed and my friend was very pleased.

Fan layout.jpg

Nutsert tool.jpg

Nutsert back side.jpg

SIL puttin it together.jpg

All fits.jpg

Final.jpg

Makers mark.jpg

installed.jpg
__________________
Scott

Last edited by Steve Hamilton; 07-10-2018 at 07:39 PM.
Reply With Quote