Quote:
Originally Posted by Peter Tommasini
I am not sure if you have done this already ? But make sure NOT!! to strike the hammer and dolly to adjust your tacks while the flux still on the panel or before washing off the flux inside and out with water and soap using a stainless steel wool pad ...then do the same when the weld is finished prior of any beating or filing..........PS do not forget to dry the whole panel from any water residue also I have been using this procedure for Years and NEVER had any flux problem
Peter
|
So is the best method to only initially flux where you tack? In case you need to adjust with hammer & dolly
__________________
Jim
"I have not Failed - I've just found 10,000 ways that have not worked" - Thomas Edison
|