Quote:
Originally Posted by AllyBill
Alternatively you could make it in four with a spine down the centre and each half made of two pieces, that way you could get each side into the wheel to wash out the shape after welding then only have the central weld to sort by hand. You'd also not have as much to scrap if one piece got away from you.
Either way will work and neither way is the 'right way' so crack on and good luck!
Will
|
Thanks. I was headed down the path of 4 pieces. But I already have two bottom 1/4's in the scrap bin and was starting to have doubts. I think I don't have the skills yet to use the wheel for more than just flattening things out a bit. Going to give hammer and stump a try for the next attempt.