Glad the build / pictures are enjoyed! I'm from a very small rural town, so there really isn't anybody else around that does the type of work I do / want to do. So it's a lot of trial and error learning as I go.
Fabbed up a small piece on the bead roller to match the profile lip of the windshield opening.
Started trimming away the a-pillar and have the new windshield opening welded into position.
Exterior a-pillar skin fit and tacked into position. (The inside of the header was cleaned and epoxied before installing the front roof skin)
Front roof skin and side panel above door also fit and tacked into position.
Rear roof corner scribed and removed.
Rear corner final fit and tacked into position.
All pieces of the roof (driver's side) are tacked into position. Now to fit and trim for the upper cab jamb.
Trimmed all roof skin panels in order to fit the upper cab jamb that I had started to fabricate earlier in the project.
All roof panels and upper cab jamb installed and checking upper door gap!
Nice even gap all around the door top! Effort well worth it!
Nice flow from all roof panels down around and into the top of the door.
Welds planished and finished. Now to do the other side and the rear panels above the rear window!