Hello everybody,
I go on my learning part.
I have done the wheel arch. The lift is no more here (as explained by Peter). So it was possible to ewheel the part.
DSCN7777.jpg
DSCN7778.jpg
DSCN7779.jpg
What I have learnt :
- the flange of the wheel arch is to large (20mm) and therefore, it's hard to stretch it evenly. I chose this dimension because I would like to put a little radius for welding.
- when i do something in the bead roller, I need a guide, for example, the border of the sheet metal but not only a pencil line.
I hope this thread will help other people. If it has no sens, please tell me.