So I've been pretty busy lately.
For a while I've been working on ways to reproduce parts of a 1977 Torana Hatchback, so far I have come up with these stamping dies I made on my old Milling machine. Basically 90% is stamped then the edges are cleaned up with hammer and dolly.
So far I have done a few tests, full length trunk sill and 3/4 lengths.
This will end up being just one stamping process of about 3 or 4 stages. Eventually the idea is to stamp out an entire rear panel like in this hand made prototype.
20171109_155225[2].jpg
20171110_191653.jpg
20171110_191500.jpg
20171110_160638.jpg
20171110_191510.jpg