Draw quality crs 18ga.
I am looking to make a trunk floor pan having deeper beads and shapes that don't seam to be able to be hammered in to regular 18ga crs with out ripping. I have raised the area with a rolling wheel to pre stretch and this doesn't seem to do it. I have yet to anneal the area. I am using the rivet gun to hammer the shapes it to a wood die. DQ should give me a deeper bead but is it suitable as a (semi) structural material. The trunk pan is about 30" by 40".
Regards
John Phillips
__________________
John Phillips "bustin rust and eating dust"
|