Worked on getting both sides cleaned up. Cut more chunks out of the driver side at the lower door hinge reinforcement.
I will probably clean this up some more as I develop the patch panels.
Before doing a bit of trimming.
I was laying on the floor looking at this for 15 or 20 minutes... Using the angle grinder to trim out junks that will serve no purpose when the patch is welded in.
I came up with a plan to fill this hole. The passenger side will be similar.
I also got the rest of the old cowl cut out of the passenger side. A little bit of finagling and I got the new cowl panel set in place. This fits very well. From what I can tell the driver side will fit well also.
Still need to build the inner patch panels.
Mark