Quote:
Originally Posted by nonhog
Probably not too tough to figure a way to bench mount that one.
Just bought my new pry bars last night. Wheels are turning!
|
The tucking forks I make you just put into a vise, the flat sides hold it very sturdy with no movement and that way it is both hand held and bench mount.
There is a very detailed procedure to make them step by step on another site (not MM) although they look easy to make as they say "The Devil is in the details"
I spent a lot of time reducing the damage the tips do to the metal.
Perhaps I can post it in the new section if there is interest and it will not cause any conflicts?