06-22-2017, 02:55 PM
|
MetalShaper of the Month October '14 , April '16, July 2020, Jan 2023
|
|
Join Date: Dec 2010
Location: Western Sierra Nevadas, Badger Hill, CA
Posts: 4,385
|
|
Quote:
Originally Posted by John Buchtenkirch
Yes, directed towards the Bonny Doon kit for nearly $3600. With the 2 vertical members so close together I think it would be very limited as far as automotive use goes……. but maybe OK for jewelry. Also even though the ultimate pressure would be higher, hand pumping a bottle jack is slow compared what you could do by hand with a arbor press. ~ John Buchtenkirch
P.S. Below is some stainless ducting for the Osprey I trued up in a hydraulic press. I powered the ram with a 2 speed log splitter pump. It ran fast till it had a load on it, then slowed as the pressure increased. Worked out surprisingly well for the job.
Attachment 42197
|
Nice solution, JB.
Good to see.
__________________
Kent
http://www.tinmantech.com
"All it takes is a little practical experience to blow the he!! out of a perfectly good theory." --- Lloyd Rosenquist, charter member AWS, 1919.
|