View Single Post
  #716  
Old 09-13-2017, 08:57 PM
Jack 1957's Avatar
Jack 1957 Jack 1957 is offline
MetalShaper of the Month Dec . 2016, Sept 2019 Metal Shaper Of The Year 2021
 
Join Date: Sep 2014
Location: Strongsville,OH
Posts: 1,131
Default

I changed my mind on using the original fender reinforcement. I can make the new on with 18ga and add an extra mounting tab about half way between the upper and lower mounting points.
I made the new ones and started with the left fender. Using the shrinker, I started carefully bringing in the profile of the fender and test fitting numerous times along the way.

Name:  926.jpg
Views: 1008
Size:  43.6 KB

Name:  927.jpg
Views: 971
Size:  40.1 KB

I made new upper mounting tabs out of 1/8" plate and welded them to the inner reinforcement. Then test fit the fender to the car to check alignment to the door and rocker.

Name:  928.jpg
Views: 973
Size:  67.9 KB

Name:  929.jpg
Views: 969
Size:  67.2 KB

Next, I am going to replace the heel of the fender since the original is in pretty rough shape and I want to slightly sweep the rear of the wheel opening back. I marked where I wanted it and made a template for the new panel.

Name:  930.jpg
Views: 988
Size:  44.5 KB

Name:  931.jpg
Views: 956
Size:  51.1 KB
__________________
Jack

Set a Goal So Big That You Can't Achieve It Until You Grow Into The Person That Can.
Reply With Quote