Quote:
Originally Posted by gerry miller
Per, Alias "Crazy Swede, Awesome watching you work. What material were you using? IE: thickness Where did you get that small almost round lower anvil? Did you make it? I always run into a problem trying to do small parts on my wiggly noodle wheel.
Gerry in Colorado
|
Nice Gerry! It is CR steel, 1 mm ( ~19ga ) no deepdraw just ordinary stuff.
The anvils are pretty old, around 20 y and made in europe, very soft tough so they need a clean up time to time
And to be honest, Im not very good to take care of mine anvils, start to be time to order a hardened set from joe