I have discovered that my 1973 450SL Mercedes unibody resto left front frame rail is deformed.
It has been repaired before but not nearly correct.
It is bent in by 16mm or 5/8"
That is at the 2 subframe mount points.
I need another subframe as well as this one matches the deformation.
Camber=NO WAY.
I have a Porto Power and wonder how I could try to bend this.
I can't push much against the other rail as that would surely bend then?
The rails are held together at the front by a nose piece.
Any ideas anyone?
The pic seems rotated here on the forum.
It is a top view of the frame member.
The red line shows where the edge if the member should be. The masonite with the plumb bob is, is on the frame ourside.
Inner and outer guards removed.
Regards
Bernt