Need a simple buck which will reverse ?? for the rear fenders of the Pickup I'm restoring, it came with 37/8 fenders which are completely wrong. Fortunately I'm also working on a 33 coupe that I can get contours data from. The build that this thread refers to can be found here
http://www.allmetalshaping.com/showthread.php?t=12747
IMG_0513.jpg
IMG_0515.jpg
IMG_0516.jpg
IMG_0517.jpg
IMG_0518.jpg
IMG_0519.jpg
The sheet represents the bed side to give a datum to work from.
IMG_0522.jpg
IMG_0521.jpg
These stations are made from 5/8" x 0.08" aluminium flat
IMG_0528.jpg
The plan is to form a set of profile gauges, cut a base and back board bracket them together, cut a curved to the wheel arch profile less the material for the rolled edge. Fix the curved piece to the base board and screw the stations in position, they will probably need to have radial support on the inside but time will tell.