Thread: C5 gto
View Single Post
  #12  
Old 12-21-2010, 10:39 PM
heinke's Avatar
heinke heinke is offline
MetalShaper of the Month Jan 2018
 
Join Date: Nov 2009
Location: Prescott, AZ
Posts: 487
Default

Ove: I did think about using a skate wheel for bottom roll. While it would result in less deformation, I don't think you'd a get the same definition/look for the diamonds. With this roll set you get an almost 3D effect. A tiny bit of deformation but it's not really visible.

Shawn: I didn't describe very well where the ventilation holes are. They are in what's best described as the transmission tunnel. So not in the floor. Normally the bottom of the transmission tunnel is not covered. I wanted the belly pan to cover the complete underside of the passenger compartment. So I put ventilation holes under where the exhaust pipes and mufflers are routed. There's aluminum covering the inside of the transmission tunnel so it's enclosed except for the front, back and ventilation holes.
__________________
Joel Heinke
Be original; don't be afraid of being bold!

Last edited by heinke; 12-25-2010 at 11:07 PM. Reason: mispelled word
Reply With Quote