I guess the answer is really “it depends in what yo are doing”
I do have kent’s Pistol grip/da setup and I like that a lot.
Generally if I start with something aggressive to knock the weld down. 3” roloc on a right angle die grinder with 36 grit. I just remove the weld, and not quite all of it. Don’y Touch the surrounding area. Then I jump up to 50 to remove the last bit of the weld and blend into the surrounding area. Then 80 and 120 on Kent’s setup, sometimes I finish up with a scotchbrite.
This is a rear frame clip I did recently using this approach. Not perfect but a huge Improvement over what is there currently
|