View Single Post
  #3  
Old 11-17-2017, 02:22 AM
Oldnek Oldnek is offline
Member
 
Join Date: Mar 2011
Location: Ulladulla, Australia
Posts: 1,346
Default

you wont need anything special there, just a standard heel dolly will work fine, due to the headlight area panel being flat. Sit your dolly on that surface and use on and off dolly technique for sharpening that line. If you need to work the area on the curved panel piece just switch the dolly over on the curve section and use same technique. Don't hit hard on dolly as you will stretch the metal. Work all those marks toward the crease line, especially on the curved side. So you have enough metal to put back on the crease.
Take your time and don't rush it.
__________________
John
EK Holden V8
Reply With Quote