I can't answering for David! But this metal is quick to respond to hammering, rolling n beading. Not to mention stump shrinking. Here is a practice wheel arch I did in about an hour n a half. I was going for a flare to the wheel arch to include tipping the opening back flat and (yet to) tip the panel under for the pinch weld to the tub. The tipped edge was easy to hammer/dolly and move around for a sharper edge. I will need to practice a lot more plenishing for a smoother panel but as easy as this metal is to move that should be no problem.
I am still looking for advice as to what panels the draw quality is best suited for.
IMG_1734.jpg