I dug out the 3 in 1 this morning and got the two channels bent up.
For a cheap HF bender this thing does a good job. I've been using it for 8 years and have not been disappointed with it...
Getting them bent the long way was the hard part. After some offhand cutting on the bandsaw I could get the them bent into the shape needed for the cowl.
There isn't much I can do to get these fit to the cowl until I get the patch panels welded in.
Passenger side.
[imghttps://media.fotki.com/2v2HofE2Fx9EDKg.jpg][/img]
Drivers side.
With the channel covers held in place. These should work!
Thanks for watching.
Mark