This air
Attachment 22896box was for a customers pick-up
I first built this aluminum frame.
Attachment 22897
This is with the filter
Attachment 22898
The cardboard mockup
Attachment 22899
Tack welded the mounting ring to some stand offs
Attachment 22900
Transfer from the paper pattern, like I learned on this site.
Attachment 22901
After cutting out the roughed in part, I bent it with the wheel and a rubber upper.
Attachment 22902
Did some hand work with a rubber hammer over a old torque tube
Attachment 22903
Bend by hand over an angle iron
Attachment 22904
Trial fit
Attachment 22905
Clamped for welding
Attachment 22906
Welded both sides so I could grind away outside welds
Attachment 22907
After sanding
Attachment 22908
Drilled and tapped for mounting the mass sensor
air box 16.jpg
Installed in pick-up. Next stop - painter