View Single Post
  #21  
Old 09-20-2019, 11:33 AM
Jaroslav Jaroslav is offline
MetalShaper of the Month April 2020, September 2021, November 2022
 
Join Date: Dec 2012
Location: Czech Republic
Posts: 2,601
Default

Thank you Bill.
Don't worry. I can make a separate thread for this machining technique. I've been using this technique for over 40 years. If interested, I can post a few cases that I normally use, but I don't know anyone else. When I talk to experts, they think I'm crazy. I understand them, they haven't seen much in practice yet, but they have the certificate.
This case did not need further protection. The force of the jaws is large enough. I worked I was taking a small chip and carefully. But without fear.
__________________
Jaroslav
Reply With Quote