All MetalShaping

All MetalShaping (https://allmetalshaping.com/index.php)
-   Introductions (https://allmetalshaping.com/forumdisplay.php?f=7)
-   -   New from North Texas (https://allmetalshaping.com/showthread.php?t=17787)

RMONTY 03-15-2018 05:47 PM

New from North Texas
 
I am an old car enthusiast, and have seen many references to this board on the various forums I frequent. I have a 1950 Chevy Sedan Delivery that I am chopping, as well as wanting to customize quite a bit.

Monty

cliffrod 04-10-2018 12:28 PM

Welcome to the forum, Monty.

Responses might be a little slow up here instead of down under the formal introduction section, but no worries. It still good to have you on the forum.


All times are GMT -5. The time now is 05:53 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.