All MetalShaping

All MetalShaping (https://allmetalshaping.com/index.php)
-   General Discussion (https://allmetalshaping.com/forumdisplay.php?f=15)
-   -   Who out there can make this canister type air cleaner? (https://allmetalshaping.com/showthread.php?t=18671)

trackhound2 01-06-2019 01:30 PM

Who out there can make this canister type air cleaner?
 
3 Attachment(s)
Attachment 50855

Attachment 50856

Attachment 50857These are approx 6-6.5" in diam.
Funnel on top and bottom.
They'd need the correct clinch/pinch/roll over type seams.
I have the "eyebrows", fitting for the top and the threaded part for the bottom.
Any suggestions?
Thanks

crystallographic 01-06-2019 03:24 PM

Quote:

Originally Posted by trackhound2 (Post 152268)
Attachment 50855

Attachment 50856

Attachment 50857These are approx 6-6.5" in diam.
Funnel on top and bottom.
They'd need the correct clinch/pinch/roll over type seams.
I have the "eyebrows", fitting for the top and the threaded part for the bottom.
Any suggestions?
Thanks


How are eyebrows attached?:confused:
Photo closeup ?
Material and thickness, please?

trackhound2 01-10-2019 02:19 AM

The eyebrows are soldered on. When I get home end of this week, I'll measure the tin and post it here..
Thanks for the interest..

trackhound2 01-13-2019 01:24 AM

Measured, its 20 or 22 gauge steel


All times are GMT -5. The time now is 11:30 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.